Mixing with one deck using Serato Scratch Lives Input reverse function

Below is a clip of a simple demonstration to show how you can use the Input Reverse function in Serato Scratch Live to mix with just one deck.

It may be useful if you can you break a needle during a set, or one deck is off for repair / servicing, or you have completely ruined one of the TCVs, There are any number of reasons that may lead you to have just one serviceable deck!

I hope it may help someone out of a sticky situation. sometime. Thank you for watching.

Tracks played:
Stir Fry - Breakin on the streets
The Soul of Man  -Scatterbox
Plump DJs - Weighed Down

You Tube Clip Link

Another discovery today, courtesy of Google finding Rik Robinson's Blog is String.TrimStart() and String.TrimEnd().

To trim a leading slash of a string or path use:

myString = myString.TrimStart(new char[]{'\\', '/'}); 

To trim a trailing slash of a string or path use:

myString = myString.TrimEnd(new char[]{'\\', '/'}); 

I had previously been using a much more long-winded approach. Cheers Rik for bringing that to my attention.

I have recently experienced a JavaScript errror incident when I started using Roles and Membership in a website for the first time.

IE6 reported a syntax error at Line 5 after adding a SiteMapDataSource and Asp.Net Menu controls to the page. The menu would not work I guess due to the JavaScript error.

A quick Google, led me to this page which led me to try adding the following code into my web config

  </system.web>
  
  <!-- Prevent JavaScript Errors, caused by web resource can't be accessed by current user. -->
  <location path="webresource.axd">
    <system.web>
      <authorization>
        <allow users="*"/>
      </authorization>
    </system.web>
  </location> 

</configuration>

This appeared to remove the error, I am assuming by allowing the web resource JavaScript to be accessed by all users.

Issue

Last night I had an issue with my Sony Ericsson W910i, where it could not be closed after it was opened. It would slide a few milimeters, but that was it.

It appears that both of the screws in behind the battery had come loose, and one of them had wound itself right out of it's threaded hole.

Solution

• Turn the phone off.
• Turn over and remove battery cover.
• Remove battery.
• Check tightness of the two screws, see attached image for location.
  • To tighten the screws you will need:
    • Either a very small Torx driver; smaller than T8, possibly a T6 or T4.
    • Or a very small flat bladed jewellers screwdriver may do it.
• Check mechanism slides smothly.
• Replace battery.
• Replace cover.
• Turn on phone.

Image

The two arrows in the phone's battery compartment show the location of the two screws.

The arrow on the batter lid shows what the screws looks like.

Summary

I had a quick google for this issue and couldn't find a resolution listed anywhere, so I hope this helps someone in the future.